E-Mu SP1200 Bedienungsanleitung PDF herunterladen (Seite 51)

SAMPLING YOUR OWN SOUNDS

2. Forced sampling is useful for situations where the signal to be sampled is more or

less continuous (continuous signals greatly complicate the threshold-setting process

described earlier). To initiate forced sampling, key in 9. The display’s top line

says,”Sampling”, while the bottom line shows the moving-bar VU meter. Sampling

will stop at the end of the programmed sample length or if the SP-1200 runs out of

memory.

3. After sampling is complete, the SP-1200 will check the sample and one of two mes-

sages will appear in the display’s top line. “Sample Overload” indicates that the

sound being sampled exceeded the SP-1200’s headroom (however, this sound is

nonetheless available for use if desired). “Sample is good” indicates that no overload

occurred.

4. If you are not satisfied with the sample, try again by keying in 6 to

re-sample the sound.

4G DELETING (ERASING) A SOUND (SET-UP 20)

Recording over a sound will erase the previous sound contents. However, you might also

want to erase a sound without recording over it in order to create more memory space.

To Erase a Sound:

1. Activate the SET-UP module and key in 20. The display will ask you which Sound

you want to delete.

2. Key in the Sound to be deleted with the keypad. The display will ask you to confirm

your choice by pressing YES (if you press NO, you will remain in the module,

whereupon you can re-select the Delete function or any other SET-UP module func-

tion).

3. After pressing YES, the sample will be deleted.

Note: If you have copied a sound over to another bank, deleting the original sound will not

erase the copied sound. The copied sound must itself be specifically erased. Here’s an

example to help get the point across:

Suppose you record a tambourine in sound location A7, then copy this over to bank D,

cowbell sound. Erasing A7 will not erase the tambourine sound that replaced the cowbell

sound in bank D. To erase the bank D sound, in step 2 above press the cowbell play button.

The tambourine sound which had been copied over will be erased.

1 2 ... 46 47 48 49 50 51 52 53 54 55 56 ... 102 103

Keine Kommentare

E-Mu SP1200 Bedienungsanleitung Seite 51