E-Mu SP1200 Bedienungsanleitung PDF herunterladen (Seite 14)

GETTING READY

1E ADJUSTING THE MIX

1. Press the TUNE-MIX-MULTI switch (towards the upper left corner of the Perfor-

mance module) until the MIX LED lights. The display graphically shows the level of

each drum in the selected bank.

2. Vary the slider above the corresponding Drum Play button to vary the level of each

individual drum. As soon as you move the slider, the graph in the display will jump

to its new position.

3. Note that MIX settings are not stored while in segment mode. If you come up with a

particularly good mix, you can save the mix as described in Section 1K.

1F TUNING THE DRUMS/CHANGING DECAY (SET-UP 18)

1. You may tune or change the decay time of any of the drum sounds. Cymbals may

also be tuned, but due to the nature of the SP-1200’s tuning change hardware, the

sound will probably be different from your expectations of a “tuned cymbal” (SP-

1200 tuning creates more of a ring modulation type of effect).

2. Each sound may be programmed to have its tuning or decay (but not both) varied

by its associated slider while the TUNE/DECAY LED is lit. Whether the slider af-

fects tuning or decay is programmed in the SET-UP module. Activate SETUP, then

key in 18. Play the desired sound. The display will indicate whether the sound is

“TUNED” or “DECAYED”. Key in 1 if you want the slider to vary the tuning, or 2 if

you want the slider to vary the decay. Drums and claps default to tuning variations,

while cymbals default to decay variations.

3. Press the TUNE-MIX-MULTI switch until the TUNE/DECAY LED lights. Sounds

which are set for decay mode have a small diagonal line above the drum sound

number. The display graphically shows the relative tuning or decay of each drum;

the center line indicates normal pitch or decay.

4. Vary the slider above the corresponding Drum Play button to vary the individual

tuning (plus or minus a fifth) for each drum set for tuning change. As soon as you

move the slider, the corresponding display graph will jump to its new position. The

higher-pitched the drum, the taller the bar; the lower-pitched the drum, the shorter

the bar. With those sounds set for decay change, varying the slider changes the

amount of decay. The longer the decay, the taller the bar; the shorter the decay, the

shorter the bar.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 102 103

Keine Kommentare

E-Mu SP1200 Bedienungsanleitung Seite 14