E-Mu SP1200 Bedienungsanleitung PDF herunterladen (Seite 18)

GETTING READY

1M ASSIGNING DRUM SOUNDS TO OUTPUT CHANNELS

(SET-UP 17)

The MIX OUT jack carries a mono mix of the SP-1200’s eight individual drum outputs; MIX

VOLUME regulates the overall level.

The SP-1200 also has eight individual output channel jacks. These are typically used in the

studio to send different sounds to different mixing console channels.

Since there are more than eight drum sounds, there is a default pre-set assignment that

determines which drums go to which channels. However, this may be changed in the

following manner:

1. Activate the SET-UP Module by pressing its switch. Its LED will glow, and the

display will ask for a function from the list printed to the right of the SET-UP switch.

2. Key in 17 (CHANNEL ASSIGN). The display asks you to select a sound; select it

using the appropriate Bank select and Drum Play buttons. Note that you can con-

secutively hit different play buttons to see the channels to which different sounds are

assigned.

3. The display now confirms your Drum Sound choice and shows its existing output

channel assignment. To change this assignment, enter a number from 1 to 8 via the

keypad. The drum sound will now appear at the like-numbered output jack on the

rear panel. This information is stored with mixes (Section 1K).

Note: There are 3 different types of filtering on the outputs. Channels 1 and 2 have dynamic

filters whose bandwidth varies in time, channels 3, 4, 5, and 6 are filtered by a constant

amount, and channels 7 and 8 are totally unfiltered. Knowing this can be handy when

assigning sampled sounds, as different sampled sounds may respond better to particular

amounts of filtering. To hear the filter effects, select a drum sound and assign it to each

channel in succession, carefully noting the difference in sound between the different chan-

nel assignments.

• The unfiltered versions of each output are available by inserting a standard phone

plug into the individual output jacks. This will also disconnect the channel from the

MIX OUT jack. Note that without any filtering, some sounds may sound very

“gritty” and noisy. You may need to “EQ” the sound at the mixing board. The fil-

tered versions of each individual output are available by using a stereo plug and

connecting to the ring of the plug. The MIX OUT jack reflects the filtered outputs of

all eight channels.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 102 103

Keine Kommentare

E-Mu SP1200 Bedienungsanleitung Seite 18