E-Mu SP1200 Spezifikationen PDF herunterladen (Seite 49)

PROPRIETARY DATA: This document contains proprietary data of ABB Inc. No disclosure, distribution (electronic or otherwise),

or other means of dissemination may be made without written permission.

3BUS 208 000 R1301 27Hardware Installation

Dimensions and Weight

The Scanning Platform is supplied in standard lengths between the pedestal center

lines as indicated in Table 3-1. Weights include sensors and dollies.

Table 3-1 Dimensions and Weight

Space Requirements

Installation requirements are dependent upon the facilities and space available at

the site location. Refer to the general installation plans made prior to installation

of the Scanning Platform.

The customer-supplied platform supports must be flat and unobstructed. Allow

sufficient access space around the support for cables to be connected and

disconnected.

It is advisable to drill necessary cable holes through the concrete floor before the

pedestals are mounted. A single hole of approximately 3 in. (75 mm) in diameter

and located near the idler end is sufficient. A similar hole can be used for the liquid

cooling unit. See Figure 3-3 on page 33.

Dash

Number

Standard

Length for

Hole Centers

Maximum

Trim

Weight

mm in. mm in. kg lb.

004 4000 157.5 2235 97.9 1659 3661

005 5000 196.9 3235 127.4 1925 4248

006 6000 236.2 4235 166.7 2191 4710

007 7000 275.6 5235 206.1 2457 5243

008 8000 315.0 6235 245.5 2723 6011

009 9000 354.3 7235 284.8 2989 6597

010 10000 393.7 8235 324.2 3255 7184

011 11000 433.1 9235 363.6 3521 7773

012 12000 472.4 10235 403.0 4787 8358

1 2 ... 44 45 46 47 48 49 50 51 52 53 54 ... 287 288

Keine Kommentare

E-Mu SP1200 Spezifikationen Seite 49