E-Mu SP1200 Spezifikationen PDF herunterladen (Seite 68)

PROPRIETARY DATA: This document contains proprietary data of ABB Inc. No disclosure, distribution (electronic or otherwise),

or other means of dissemination may be made without written permission.

3BUS 208 000 R130146 Hardware Installation

7. Thread two parallel lengths of wire over the rolls onto which the process is

being guided. See Figure 3-12.

These wires should be placed in the positions that are representative of the

outside edges of the process sheet.

8. Suspend a weight of approximately 5 lb. (3 kg) from each end of the wire.

Figure 3-12 Simulating the Process Pass Line

9. Rotate the lower head to the desired pass angle.

10. Tighten the four locking M8 bolts (lower adapter plate mounting bolts) on each

side of the bottom carriage. See Figure 3-11 on page 45.

11. Remove the top cover of the upper head. .

12. Loosen upper adapter plate mounting bolts and remove the mounting bolts with

eccentrics. See Figure 3-13 on page 47.

13. Loosen the adapter plate extension mounting bolts. See Figure 3-13.

14. Adjust the four vertical adjustment screws so that the weight of the upper

carriage rests on the bolts of the upper adapter plate.

This is done so that when you adjust the air gap between the upper and lower

sensor heads you have enough slack to move the upper head vertically.

15. Rotate the upper head package to approximate pass angle and move the upper

head package directly over the lower head package.

16. Rotate the upper head package to match the lower head package angle closely

by visual inspection.

17. Tighten the upper adapter plate extension mounting bolts. See Figure 3-13.

Stretched wire

representing sheet

edge

Customers Roll

Weight

1 2 ... 63 64 65 66 67 68 69 70 71 72 73 ... 287 288

Keine Kommentare

E-Mu SP1200 Spezifikationen Seite 68