E-Mu SP1200 Spezifikationen PDF herunterladen (Seite 70)

PROPRIETARY DATA: This document contains proprietary data of ABB Inc. No disclosure, distribution (electronic or otherwise),

or other means of dissemination may be made without written permission.

3BUS 208 000 R130148 Hardware Installation

Process Direction Alignment

Note: When aligning the head packages, reference points will be located

on the Basis Weight sensor plate. If a Basis Weight sensor is not

present, use the Ash sensor for the alignment reference. If neither

the Basis Weight or Ash sensors are present, use the Basis Weight/

Ash sensor’s blank base plate. If a Smart Caliper GT is present, one

reference point will be located on the caliper sensor.

1. Use a machinist straight edge [or the back side of the air gap tool (Part Number

128624-001)] to make certain that the upper and lower heads are parallel. They

should be flush within

± 0.005 in. (0.127 mm). See Figure 3-14.

Figure 3-14 Process Direction Alignment Points

Upper

Head

Use Feeler

Gauge Here

Machinist’s

Straight

Edge

Lower

Head

1 2 ... 65 66 67 68 69 70 71 72 73 74 75 ... 287 288

Keine Kommentare

E-Mu SP1200 Spezifikationen Seite 70