E-Mu SP1200 Spezifikationen PDF herunterladen (Seite 59)

PROPRIETARY DATA: This document contains proprietary data of ABB Inc. No disclosure, distribution (electronic or otherwise),

or other means of dissemination may be made without written permission.

3BUS 208 000 R1301 37Hardware Installation

Attaching the Platform to the Pedestals

This section describes the attachment of the Scanning Platform to the pedestals.

1. Transport the Scanning Platform on its shipping dollies or skids to the

installation site.

2. Remove the end column doors to avoid damaging them during placement.

3. Coat the entire top surface of both pedestals with a corrosion preventive

compound.

4. Install shims. Refer to Figure 3-5 and Figure 3-6 on page 38.

Install the 0.5 in. (13 mm) plate at the drive end. Install the 0.375 in. (10 mm)

plate and the 0.25 in. (6 mm) Teflon

® pad at the idler end.

Figure 3-5 Attaching Drive Side of Scanning Platform to Pedestals

Drive Side

Base 25 mm (1.0 in.) thick

Steel mounting plate

13 mm (0.50 in.) thick.

Seating for screws

If tapped 1.25 in. holes are used in the

pedestals instead of through holes for

mounting the platform, drill and tap

3/8 x 16 or M10 x 1.5 through to tapped

hole for set screw to lock mounting bolt

Slot to allow for aligning

platform parallel to process

rolls, and calender.

1 2 ... 54 55 56 57 58 59 60 61 62 63 64 ... 287 288

Keine Kommentare

E-Mu SP1200 Spezifikationen Seite 59